Product Documentation
Abstract
8202-E4B (Power 720) and 8205-E6B (Power 740) - memory dimm installation movie
Content
Memory modules installation
To install the memory modules, follow these steps:
- Ensure that the connector locking tabs are pushed open into the unlocked position before installing a new memory module.
- Carefully grasp the memory module along the edge and align it with the connector.
Attention: Memory modules are keyed to prevent a memory module from being installed incorrectly. Note the location of the key tab within the memory module connector before attempting to install the memory module. - Push the memory module firmly into the connector until it locks.
-
Replace the memory riser:
- Align the memory riser with the connector.
- Press firmly into the connector.
- Press the locking tabs into the closed position.
- Replace the service access cover.
- Reconnect the power source.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1P1","label":"Power->Power 720"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1S1","label":"Power->Power 740"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5086910