Operator information panel assembly removal movie - IBM System x3850 X5 (7145, 7146), System x3950 X5 (7145)

Content

• Movie player help

Text from the audio portion of the operator information panel assembly removal movie

To remove the Operator Information Panel Assembly:

1. Remove the top cover:
   
   
   1. Turn off the server and all peripheral devices and disconnect all power cords and external cables.
      
      
   2. Press the button and lift the cover-release latch. The cover will move to the rear approximately one half inch.
      
      
   3. Lift the cover off the server and set it aside.
      
      
2. Remove the Front Bezel:
   
   
   1. Press in on the bezel retention tabs at the sides of the bezel, and lift the bezel from the server.
      
      
   2. Remove the Memory Cards or filler panels in slots 6, 7, and 8.
      
      
   3. Slide the blue release lever toward the rear of the server, rotate the retention levers to the open position, and then lift the memory card out of the server and place it on a static protected surface.
      
      
   4. Grasp the filler panels and lift them from the chassis.
      
      
3. Remove the Operator Information Panel Assembly:
   
   
   1. Disconnect the cable from the operator Information Panel.
      
      
   2. Press the release latch and pull the operator information panel out.
      
      
   3. Push the blue release button above the assembly and pull the assembly out of the server.
      
      

• View the operator information panel assembly installation movie
• Return to matrix

For specific instructions for the removal and installation of hardware.

• Problem Determination and Service Guide - IBM System x3850 X5, x3950 X5 (7145, 7146)