Memory modules installation - 8233-E8B (Power 750), 8236-E8C (Power 755)

Content

• Movie player help

Memory modules installation

To install the memory modules, follow these steps:

1. Ensure that the connector locking tabs are pressed out in the unlocked position before installing a new memory module.
2. Carefully grasp the memory module along two edges and align the connector.
3. Insert the memory module firmly into the connector.
4. Secure the memory module with the locking tabs located at each end of the memory module connector.
5. Close the memory module cover until it locks in place.
6. Replace the system processor assembly.
7. With the latches in the unlocked position, correctly align the system processor assembly and slide it through the guide rails into the system backplane assembly.
8. Move the latches down to lock the system processor assembly into position.
9. Replace the service access cover.
   1. Place the service access cover on the top of the system unit, approximately 25 mm (1 in.) from the front of the system unit.
   2. Hold the service access cover against the system unit, and slide it toward the front of the system.
   3. Tighten the screws located at the back of the cover.
10. Place the system in the operating position.
    1. To unlock the rail safety latches, slide the latches toward the front of the system.
    2. Push the system unit back into the rack until both system-unit release latches lock into position.
    3. Replace and tighten the two screws that secure the system unit to the rack.

• View memory removal movie
• Return to components list

• Power Hardware Information Center