Product Documentation
Abstract
9117-MMB (Power 770) - DASD backplane "installation" movie
Content
DASD backplane installation
To install the DASD backplane, follow these steps:
-
Install the disk drive backplane.
- With the handles in the fully extended position, align the disk drive backplane with the enclosure slot.
- Slide the disk drive backplane into the enclosure until it stops, and then rotate the handles in the direction shown to lock them in place.
- Install the DVD drive.
- Install all the disk units and fillers.
- Install the RAID - dual IOA enablement card.
- Install the control panel and assembly.
-
Install the front cover.
- Position the cover on the front of the system unit so that the four pins on the system match the four holes on the back of the cover.
- Press the tabs to snap the cover into position.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1L1","label":"Power->Power 770"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1M1","label":"Power->Power 780"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5083704