Product Documentation
Abstract
9117-MMB (Power 770) - RAID cache battery pack "installation" movie
Content
RAID cache battery pack installation
To install the RAID cache battery pack, follow these steps:
-
Replace the cache battery pack as follows:
- Ensure that the cache battery pack is disconnected for at least 60 seconds before you connect the new battery. This is the minimum amount of time needed for the card to recognize that the battery has been replaced.
- Slide the new replacement cache battery pack into the controller until it is fully seated.
- Verify that the tab returns to the latched position.
-
Install the front cover.
- Position the cover on the front of the system unit so that the four pins on the system match the four holes on the back of the cover.
- Press the tabs to snap the cover into position.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1L1","label":"Power->Power 770"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1M1","label":"Power->Power 780"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5083701