USB Cable and Light Path Diagnostic Assembly installation movie - IBM System x3400 M2, x3500 M2

Content

• Movie player help.

Text from the audio portion of the USB Cable and Light Path Diagnostic Assembly installation movie

To install the USB Cable and Light Path Diagnostic Assembly:

1. Squeeze the retaining clips on each side of the USB cable connector and insert the connector into the mounting bracket then release the retaining clips.
2. Feed the cables into the server then insert the hinge tab on the bottom of the bracket into the slot in the chassis and rotate the top of the bracket toward the server until it latches into place.
3. Route the light path diagnostic cable in the server and secure in the retainers, and then connect it to the system board.
4. Route the USB cable in the server and secure in the retainer and connect it to the system board.
   

Install the Fan Cage Assembly:

1. Before installing the Fan Cage assembly, insure that all cables are routed correctly in their retainers.Place the fan-cage assembly into the server, using the guides on the fan cage and the release latches for alignment and press in until latched in place.

Install the Air Baffle:

1. Place the air baffle into the server using the positioning pins on the air baffle and the locating holes in the server and fan-cage assembly for alignment, and then press down until latched in place.
2. Press the locking tab to release the power supply cage and then rotate the cage into the server and lower the handle. Here is a closer look at a positioning pin on the baffle and a hole in the fan cage assembly.
   
   Note: use care to ensure that the power cables are routed so they are not pinched when closing the cage.Improper routing, as shown, here will cause damage to the cables.
   
   
3. Return the server to its normal operating position.

Install the Hot-swap Power Supplies:

1. Slide the Power Supply into the bay until secured by the latch.
2. Use the same procedure to install the second power supply if required.
   
3. Return the server to its normal operating position.
4. Connect the power cord to the power supply.

Install the side Cover:

1. Position the channel on the cover over the rail on the bottom edge of the chassis.
2. Rotate the cover toward the chassis and then press down on the cover release latch and close the cover
3. Lock the side cover if required.

Install the Bezel:

1. Align the hinge assemblies with the holes on the chassis and press in until seated.
2. Rotate the left side of the bezel towards the server until closed.

• Problem Determination and Service Guide - IBM System x3400 M2 (7836, 7837)
• Problem Determination and Service Guide - IBM System x3500 M2