Product Documentation
Abstract
IBM System x3650 M2, x3650 M3 - SAS riser-card and controller assembly removal movie
Content
Text from the audio portion of the SAS riser-card and controller assembly removal movie
To remove the SAS riser-card and controller assembly:
Note: this procedure only applies to servers with tape drives installed.
- Turn off the server and peripheral devices, and disconnect all power cords and external cables.
Remove the top cover:
- Push in on the button to release the top cover latch and then rotate it up. The cover will move approximately one-half inch to the rear.
- Lift the cover off and set it aside.
(Remove the SAS riser-card and controller assembly:)
- Disconnect the two SAS data cables from the serveraid adapter card.
- Press the release tab toward the center of the server and lift the SAS controller to disconnect it from the system board, then lift the controller up and rotate it to access the cables.
- Slide the blue locking collar on the connector toward the riser card to unlock it and then disconnect the signal cable.
- Disconnect the power cable and remove the assembly from the server.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"QU03WCX","label":"System x->System x3650 M2->7947"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"QU04SLL","label":"System x->System x3650 M3->7945"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5082278