USB/video cable installation movie - IBM System x3550 M2 (7946), x3550 M3 (7944)

Content

• Movie player help

Text from the audio portion of the USB/video cable installation movie

To install the USB/video cable:

1. Feed the cables into the cutout in the front of the chassis, position the usb cable through the notch and remove any slack from the cables.
2. Connect the cable to the system board.

Install the bezel:

1. To obtain additional clearance to install the bezel remove any drives or filler panels installed in the top row.
2. Insert the tabs on the bottom of the bezel into the slots in the chassis.
3. Position the video connector in the bezel then rotate the top of the bezel towards the chassis.
4. Install the two hex studs securing the video connector to the bezel.
5. Secure the bezel to the chassis with the four screws.
6. Install any drives or filler panels that were previously removed.

Install the top cover:

1. Position the cover on top of the server using alignment pins on the cover and slots in the chassis for alignment.
2. Slide the cover toward the front of the server until it latches in place.

Here is a closer look at an alignment pin on the cover and a slot in the chassis

• View the USB/video cable removal movie
• Return to matrix

For specific instructions for the removal and installation of hardware.

• Problem Determination and Service Guide - IBM System x3550 M2