DIMM air duct installation movie - IBM System x3500

Content

• Movie player help

To install the DIMM air duct:

1. Slide the air duct down the power supply cage till the pins are in place and the mounting holes in the air duct match up with the screw holes in the power supply cage.
2. Using two screws, secure the air duct to the power supply cage.
   
   Here's a closer look at the pin.

Install the Power Supplies:

1. Press to release the cage locking tab, then rotate the cage down and rotate the handle down to secure it in place.
2. Place the power supply into the bay and push it in until it locks into place.
3. Use the same procedure to install Power Supply 2, if installed

Install the Bezel:

1. Insert the hinge tabs on the right side of the bezel into the slots on the server chassis; then, rotate the bezel until secured by the three latches.
   
   Here's a closer look at a hinge tab.

Install the Left-side cover:

1. Position the channel on the cover over the rail on the bottom edge of the chassis.
2. Rotate the cover closed, ensuring the latch secures it in place.
3. Lock the side cover, if required.

• Problem Determination and Service Guide