Power distribution board assembly installation movie - IBM System x3650 T (Type 7980)

Content

• Movie player help

To install the Power Distribution Board Assembly:

1. Position the assembly in the chassis using the two tabs for alignment.
2. Rotate the assembly down onto the locating pins until latched in place.
3. Connect the following cables:
   1. P2
   2. P1
   3. P3
   4. P5

4. Here is a closer look at a locating pin.

Install the Fan Assembly:

1. Position the fan assembly in the chassis using the plastic guide located on the right side frame and the alignment pins in the base as a guide.
2. Tighten the single captive screw to secure.
3. Connect the four fan power cables to the front panel board.
4. Place the fan guard in position using the tab on the cover, the slot in the chassis, and the screw holes for alignment and secure with the two captive screws.

5. Here is a closer look at the plastic guide and an alignment pin.

   Here is a closer look at the tab on the cover and the slot in the chassis.

Install the Riser Card Assembly:

1. Insert the Riser Card Assembly into the chassis using the slots on the assembly and the pins on the chassis for alignment and press down to seat.
2. Connect the PCI Card Carrier cable.

Here is a closer look at one of the slots in the assembly and a pin on the chassis.

Install the Power Supply:

1. Position the power supply into the bay and slide it into place until it is secured by the latch.

Install the CD/DVD Drive:

1. Position the drive tray into the bay and press to seat the connector. Rotate the handle to the closed and locked position.

Install the Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward until latched in place.

Here is a closer look at a cover tab and a slot in the chassis.

Install the Bezel :

1. Position the Bezel on the system using the screw holes for alignment and secure with the two captive thumb screws.

• View removal movie
• Return to matrix