Power backplane installation movie - IBM System x3650

Content

• Movie player help

To install the Power backplane:

1. Position the assembly in the base using the channels as a guide.
2. Slide it towards the system board to seat the connector.
3. Connect the Hard Disk Drive Back Plane Cable to the Power back plane.
   
   Here is a closer look at the channel, and an alignment pin on the connector.

Install the Hot-Swap Power Supply:

1. Position the power supply into the bay and slide it into place until it is secured by the latch.

Install the Hot-Swap Fan Bracket Assembly:

1. Ensure that the bracket levers are in the open position.
2. Position the bracket into the chassis using the alignment tabs as a guide.
3. Rotate the levers to the locked position and insure that all of the fans are seated
   
   Here's a closer look at the alignment tab and the slot in the chassis.

Install the Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward while rotating the cover release latch to the closed position.
   
   Here's a closer look at the cover tab and the slot in the chassis.

• Problem Determination and Service Guide