CD/DVD media backplane installation movie - IBM System x3650

Content

• Movie player help

To install the CD/DVD media backplane:

1. Position the backplane into the chassis using the screw holes for alignment and secure with the two screws
2. Connect the signal and the power cables to the media back plane.
3. Slide the drive into the bay until secured by the latches.
4. Connect the operator information panel cable to the system board and secure in place with the hook and loop fastener.

Install the Hot-Swap Fan Bracket Assembly:

1. Ensure that the bracket levers are in the open position.
2. Position the bracket into the chassis using the alignment tabs as a guide.
3. Rotate the levers to the locked position and insure that all of the fans are seated
   
   Here's a closer look at the alignment tab and the slot in the chassis.

Install the Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward while rotating the cover release latch to the closed position.
   
   Here's a closer look at the cover tab and the slot in the chassis.

• Problem Determination and Service Guide