USB cable assembly installation movie - IBM System x3350

Content

• Movie player help

Text from the audio portion of the USB cable assembly installation movie

To install the USB cable assembly

1. Position the connector in the cutout in the chassis.
2. Use a flat bladed probe to compress each spring and release it to secure the latch, one spring at a time.
3. Route the USB cable through the chassis and connect it to the system board.

Install the Media Bezel and Video Cable Assembly:

1. Feed the cable through the media bay.
2. Insert the hinge tabs on the bottom of the bezel into the slots in the chassis.
3. Rotate the top of the bezel towards the system until flush with the chassis and secure with the two screws.
   
   Here is a closer look at a tab on the Bezel and a slot in the chassis.
   
   
4. Route the video cable through the slot in the chassis and connect it to the system board.
5. Position fan number 3 over the bracket insuring that the air flow indicator is pointing to the rear of the server.
6. Push the fan assembly down until the blue mounting grommets are seated.
7. Connect the fan cable to the system board.
   
   Here is a closer look at the air flow indicator.
   
   
8. Push the Disk Drive Bay Cage Assembly into the bay until flush with the chassis and secure with the three screws.
9. Slide the drive cage assembly into the front of the server
10. Secure with the three screws.

Install the 3.5 Inch Drive Back Plane:

1. Slide the drive cage assembly into the front of the server
2. Secure with the three screws.
3. Slide the backplane into the channels in the cage assembly and press down until seated over the tab in the center.

Install the Top Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward and secure with the single captive screw.
3. Rotate the fan door to the closed and latched position.
   
   Here's a closer look at the cover tab and the slot in the chassis.
   
   
4. Gently push the drive tray into the bay until the drive connects to the backplane.
5. Install all of the drives.

• Problem Determination and Service Guide