Media bezel and video cable assembly installation movie - IBM System x3350

Content

• Movie player help

Text from the audio portion of the Media bezel and video cable assembly installation movie

To install the Media bezel and video cable assembly

1. Position the video cable in the bezel and secure with the two hex nuts.
2. Feed the cable through the media bay.
3. Insert the hinge tabs on the bottom of the bezel into the slots in the chassis.
4. Rotate the top of the bezel towards the system until flush with the chassis and secure with the two screws.
   
   Here is a closer look at a tab on the Bezel and a slot in the chassis.
   
   
5. Route the video cable through the slot in the chassis and connect it to the system board.
6. Position fan number 3 over the bracket insuring that the air flow indicator is pointing to the rear of the server.
7. Push the fan assembly down until the blue mounting grommets are seated. Connect the fan cable to the system board.
   
   Here is a closer look at the air flow indicator.
   
   
8. Slide the drive cage assembly into the front of the server
9. Secure with the three screws.
10. Slide the backplane into the channels in the cage assembly and press down until seated over the tab in the center.
11. Gently push the drive tray into the bay until the drive connects to the backplane.
12. Install the filler plates.

Install the Top Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward and secure with the single captive screw.
   
   Here's a closer look at the cover tab and the slot in the chassis.
   
   
3. Rotate the Fan Door to the closed and latched position.

• Problem Determination and Service Guide