Product Documentation
Abstract
Media bezel and video cable assembly removal movie - IBM System x3350
Content
Text from the audio portion of the Media bezel and video cable assembly removal movie
To remove the Media bezel and video cable assembly
Turn off the server and all peripheral devices and disconnect all power cords and external cables.
Remove the Top Cover:
- Slide the cover release latches and rotate the Fan Door open.
- Loosen the captive screw on the rear of the chassis.
- Slide the cover towards the rear of the server approximately one half inch and then lift the cover off the server and set it aside.
Remove the 3.5 Inch Drive Back Plane:
- Disengage the drives from the back plane
- Raise the backplane out of the slots in the drive cage.
- Remove the three screws securing the cage assembly.
- Slide the drive cage assembly out two inches to clear the media bezel.
- Disconnect the cable for fan 3 , then grasp the pull tab on fan number 3 and lift it out of the bracket and place it aside to gain access to the cable.
- Disconnect the Video cable from the system board.
- Remove the two screws from the top of the Bezel.
- Rotate the top of the bezel away from the system and press down to free the hinge tabs on the bottom.
- Pull the Bezel away from the system while carefully feeding the cable through the media bay.
To remove the video cable from the bezel, remove the two hex nuts securing the cable to the bezel
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW336","label":"System x->System x3350"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5074955