Power backplane installation movie - IBM System x3350

Content

• Movie player help

Text from the audio portion of the Power backplane installation movie

To install the Power backplane

1. Position the assembly in the base using the posts in the base and the keyholes in the card as a guide.
2. Slide it towards the system board to seat the connector.
3. Connect the Hard Disk Drive Back Plane Cable to the Power back plane.
   
   Here is a closer look at the keyhole in the card and a post in the base.

Install the Top Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward and secure with the single captive screw.
3. Rotate the fan door to the closed and latched position.
   
   Here's a closer look at the cover tab and the slot in the chassis.

Install the Hot-Swap Power Supplies:

1. Position the power supply into the bay and slide it into place until it is secured by the latch.
2. Connect the power cord.

• Problem Determination and Service Guide