Power supply installation movie - IBM System x3455

Content

• Movie player help

Text from the audio portion of the power supply installation movie

To install the power supply

1. Position the power supply into the server using the keyhole slot in the power supply and the retainer pin in the chassis for alignment. Slide the power supply towards the rear of the server and secure with the three screws.
2. Here is a closer look at the keyhole slot in the power supply and the retaining pin in the chassis.
3. Connect cables P7, P2, P1, and P3 to the system board.
4. Connect the power cables to the hard disk drive and the optical drive backplane and then secure them in the cable retainer.
5. Install the air baffle for processor two.

Install the top cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward, ensuring that the channel in the front of the cover engages edge on the chassis, and secure with the single captive screw.
3. Here is a closer look at a slot in the chassis and a tab on the cover.
4. Here is a closer look at the channel on the front of the cover.

• View power supply removal movie
• Return to matrix

• Problem Determination and Service Guide