Front USB cable installation movie - IBM System x3655

Content

• Movie player help

Text from the audio portion of the front USB cable installation movie

To install a front USB cable

1. Connect the USB cable to the System Board.
2. Position the spring clip on one side of the connector into the slot in the front bezel and then use a flat blade probe or screwdriver to compress the other spring retainer while rotating the connector into the bezel.
3. Release the spring retainer to secure the connector.

Install the fan bracket assembly:

1. Using the guides on the assembly and the slots in the chassis for alignment lower the fan-bracket assembly into the chassis.
2. Push the fan-bracket-assembly levers toward the rear of the server until they stop then pinch the release latches and metal tabs together and push the levers down into place
3. Press down on the metal tabs and the fans to be sure the fan-bracket assembly is fully seated.

Install the top cover:

1. Position the cover over the chassis, aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward while rotating the cover release latch down to the closed position.

• Problem Determination and Service Guide