Front USB connector assembly installation movie - IBM System x3200

Content

• Movie player help

Text from the audio portion of the front USB connector assembly installation movie

To install a front USB connector assembly

1. Squeeze the spring clips on the sides of the connector while inserting the connector into the housing.
2. Release the spring clips to secure the connector.
3. Carefully insert the cable through the opening in the front of the chassis.
4. Place the tab on the bottom edge of the housing into the opening in the chassis and then rotate it up until secured by the latch.
5. Connect the USB cable to the system board.
6. Return the server to its operational position.

1. Insert the two hinge tabs on the right side of the upper bezel into the slots in the chassis then rotate the bezel until secured in place.

1. Insert the two tabs at the bottom of the lower bezel into the slots in the chassis and then rotate the top of the lower bezel toward the server until it latches in place.
   

• Problem Determination and Service Guide