Control panel installation movie - IBM System x3105

Content

• Movie player help

1. Connect the control panel cable and USB cable to the control panel card.
2. Carefully thread the cables into the cutout in the chassis.
3. Position the panel hinge tab into the slot in the chassis and rotate the panel down. Secure with the single screw.
4. Route the cables under the cable retainer.
5. Connect the USB cables and control panel cable to the system board.
6. Release the spring retainer and rotate the drive cage down. Secure with the single thumbscrew.
7. Connect the drive power cable.

1. Insert the two hinge tabs on the top of the Bezel into the slots in the chassis and then rotate the bottom of the bezel into the chassis until secured by the bezel release tab.
   Here is a closer look at a hinge tab.

1. Place the front edge of the cover into position on the front edge of the server and lower the cover onto the chassis.
2. Slide the cover toward the front of the server and secure with the two thumbscrews.
3. Return the server to its normal operating position.
   

• Problem Determination and Service Guide