Product Documentation
Abstract
Instructions for removing the Remote Supervisor Adapter II rom any xSeries 366 and xSeries 460 server.
Content
Text from the audio portion of the Remote Supervisor adapter movie
To install the RSA II adapter:
- Position the adapter card over the I/O board using the connectors for alignment.
- Press the card until seated and secured by the latches.
- The cover slides to the rear, approximately one-half inch
- Lift the cover off the server.
Install the I/O board:
- Position the I/O board in close proximity to the connector. Connect the USB power cable to the I/O board.
- Align the I/O board with the guides in the server, and slide the board in until it latches in place.
Connect the following cables to the I/O board:
- 2 SAS signal
- DVD signal Install the top cover
- Position the cover on the chassis while aligning the tabs on the cover with the slots in the chassis.
- Slide the cover toward the front of the system, and secure it with the cover-release latch handle.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW20Y","label":"Older System x->xSeries 366"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW21J","label":"Older System x->xSeries 460"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW21K","label":"Older System x->xSeries MXE 460"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-62954