Non-hot swap hard disk drive removal movie - IBM eServer 325

Content

• Movie player help

Text from the audio portion of the removing the non-hot swap hard disk drive movie

Remove the cover:

1. Turn off the server and all attached peripheral devices. Disconnect all power cords; then, disconnect all external signal cables from the server.
2. Remove the server from the rack. Then, lift the cover release latch; slide the cover to the rear, lift up the front of the cover, and then lift off the cover.

To remove the USB Option Tray:
Press in on the USB option tray (below hard disk drive bay 1) to release it and slide the tray out until it stops; then, press the retention clip at the bottom rear of the tray and remove the tray from the server

To remove the front bezel:
Press on the bezel retention tabs on the top and bottom of the left side of the bezel, on the top and side of the right side of the bezel, and then pull the bezel directly away from the server.

To remove the non-hot-swap hard disk drive:

1. Disconnect the signal cable and the power cable.
2. Squeeze the latches on the rails, and pull out the drive.
3. Remove the rails, remove the two screws holding each rail in place and lift the rail off.

• Problem Determination and Service Guide