Hard drive installation movie - IBM eServer xSeries 206

Content

• Movie player help

Text from the audio portion of installing a hard disk drive movie

To install the hard disk drive in bay 5, 6, or 7:

1. Position the drive tray over the disk using the alignment pins as a guide, and secure with four screws.
   Note: When adding a non-hot-swap SCSI hard disk drive, be sure to follow the manufacturers instructions on how to set the SCSI ID number.
2. Align the drive tray with the channels in the drive bay and insert the drive all the way into the bay.
3. Position the tabs on the bay retainer into the slots on the front cover and rotate down.
4. Grasp the drive bay cage and gently rotate it up into the open position.
5. Connect the SCSI and power cables.
6. Release the drive bay cage latch and gently rotate the cage down to the closed position.
7. Install the side support bracket:
   1. Hold the bracket at a 45-degree angle and engage the locking tab at the front.
   2. Lower the rear of the bracket and press it into place.
8. Install the side cover:
   1. Position the cover over the chassis and align the tabs on the cover with the slots in the chassis.
   2. Slide the cover forward while rotating the cover release latch to the closed position. Here is a closer look at the cover tab and a slot in the chassis.
9. Install the front door: Align the door pins with the hinge latches and press into place. Here is a closer look at the front door hinges.

• View the hard disk drive removal movie
• View detailed installation and removal instructions for the xSeries 206