Viewing or changing integrated server configuration information
Use either IBM® Navigator for i or CL commands to view or change integrated server configuration information.
Note: Some IBM i configuration object properties cannot be changed while the object is active, or in use by an active server. See the appropriate configuration object command documentation for restrictions.
If you want to change a property that cannot be changed while the configuration object or associated server is active, perform one of the following tasks before changing the configuration object properties.
View and change integrated server configuration information as follows:
Using the character-based interface you can view and change all integrated server configuration information. The following table summarizes the relevant CL commands.
Tasks | CL Command |
Vary on and off integrated servers, check the status of the integrated server and objects that are associated with the network server description (NWSD). | WRKCFGSTS CFGTYPE(*nws) |
Manage your integrated servers. | WRKNWSD WRKNWSSTS |
Manage line descriptions that are created when you install the integrated server. | WRKLIND |
Manage TCP/IP interfaces that are created during server installation. | NETSTAT OPTION(*IFC) CFGTCP, option 1 |
Monitor virtual storage (network server storage spaces). | WRKNWSSTG |
Vary on and off iSCSI targets and check the status of the network server host adapter (NWSH). | WRKCFGSTS CFGTYPE(*DEV) CFGD(*NWSH) |
Manage network server host adapters | WRKDEVD DEVD(*NWSH) |
Manage remote system and service processor network server configurations | WRKNWSCFG |