$T REDIRect - Redirect command responses
Function
To change redirection for commands entered at the entry console. The operator should use $T REDIRect if redirection was specified already through the redirect initialization statement or a previous $ADD REDIRect for this console.
In a sysplex, if a JES2 subsystem has SCOPE=SYSTEM on its CONDEF initialization statement, redirection will not be in effect for that subsystem. To have that subsystem take part in the redirection, issue the $T or $ADD REDIRect command on that JES2 subsystem.
Syntax
Parameters
- *
- Specifies all entry consoles that have been added or redirected at initialization as the active MCS console. This parameter resets the response locations for the indicated command groups.
- DA=da
- Display active job.
- DCONNECT=dconnect
- Display JES2 network connections.
- DEF=def
- Display JES2 parameter definitions.
- DF=df
- Display forms queue.
- DI=di
- Display initiators.
- DJ|DS|DT=dj
- Display JOB, STC, TSU information.
- DN=dn
- Display queued jobs.
- DNODE=dnode
- Display NJE nodes.
- DQ=dq
- Display number of queued jobs.
- DSPL=dspl
- Display spool volumes.
- DU=du
- Display units.
- LJ|LS|LT=lj
- List JOB, STC, TSU output.
- redirect
- Specifies
the active MCS console at which the specified output appears. If
you only specify an area, the output appears in the indicated area
of the entering console. If area is omitted, then the default area
defined on the CONDEF RDIRAREA= operand is used. This parameter is
required. Define the redirect area/console as one of the following:
- a
- An output area ID
- name
- A console name
- name-a
- A console name and output area
Authority Required
This command requires system authority. The description of the $T RDRnn command explains how to ensure that the authority of the appropriate MVS™ system command group is assigned.
This command requires control security access authority. For a description of assigning command input authority, see z/OS JES2 Initialization and Tuning Guide.
Scope
Single member. This command will be in effect for this member only. There is no need to have this command issued to all members of the MAS.
Messages
The $HASP818 message is issued in response to this command. The $HASP003 rc=52 message is issued if a $T REDIRECT is entered for this console before an initial redirection is specified for this console. The $HASP0003 rc=62 message is issued if a $T REDIRECT is entered to set redirection to an invalid console.
Examples
1 $t redir(cn3e0),du=cn320
2 $t redir(cn320),du=cn3e0-a
3 $t redir(cn3e0),di=a,du=a
Sets up redirection for the $di and the $du commands. When you issue these commands on console CN3E0, the responses are displayed in the out-of-line area A of console CN3E0.