GIM39402ISMPTLIB DATA SETS WERE LOADED FOR SYSMOD sysmod. THE RETURN CODE FROM THE COPY UTILITY WAS rtncode.
SMPTLIB DATA SETS WERE LOADED FOR SYSMOD sysmod.
THE RETURN CODE FROM THE COPY UTILITY WAS rtncode.
Explanation
- sysmod
- SYSMOD ID
- rtncode
- maximum return code from the copy utility
The copy utility successfully loaded the SMPTLIB data sets for the indicated SYSMOD. The copy utility issued a nonzero return code less than or equal to the acceptable return code that was specified in the associated UTILITY entry.
System action
SYSMOD processing continues. SMP/E indicates that the indicated SYSMOD has been received successfully.
Programmer response
Check the copy output in SYSPRINT to find
the cause of the nonzero return code, and determine whether this would
adversely affect further processing.
Note: If you did not get any
utility output, check the value specified for the PRINT subentry in
the UTILITY entry. This ddname is used for the SYSPRINT data set.
Here are some typical reasons for not getting any utility output:
- The PRINT subentry specifies a DDDEF of DUMMY.
- The PRINT subentry specifies a data set that is sent to a SYSOUT class that suppresses output.