07 | 01, 02, 03, 04 | Another message indicates the cause
of the problem. | Read the other messages to see what action is necessary. |
08 | 01, 02, 03, 04 | Another message indicates the cause of the problem. | Read the other messages to see what action is necessary. |
09 | 01, 02, 03, 04 | Another message indicates the cause of the problem. | Read the other messages to see what action is necessary. |
0A | 01, 02, 03, 04 | Another message indicates the cause of the problem. | Read the other messages to see what action is necessary. |
0B | 01, 02, 03, 04 | Another message indicates the cause of the problem. | Read the other messages to see what action is necessary. |
11 | 01 | The Print Interface subsystem had
an internal error. The Print Interface subsystem server has stopped
and restarted. | Resubmit the print job. If the problem recurs, notify your
system programmer or IBM® service
representative. |
08 | The Print Interface subsystem server
is busy. | Resubmit the print job at a later time. |
12 | 07, 08 | The Print Interface subsystem was
not running. | After the operator runs the aopstart command
or the AOPSTART procedure to restart the Print Interface subsystem,
resubmit the print job. |
14 | 04 | The Print Interface subsystem had
an internal error. The Print Interface subsystem server has stopped
and restarted. | Resubmit the print job. If the problem recurs, notify your
system programmer or IBM service
representative. |
16 | 01 | The region size is too small. | Increase the region size for the print job and resubmit it. |
17 | 01 | The application that created the
output data used either an unsupported access method or access method
function. | Change your application to use either the QSAM or BSAM access
method. Use only the OPEN, CLOSE, and PUT functions. Resubmit the
print job after the application has been changed. |
07, 08 | The Print Interface subsystem was
not running. | Restart the Print Interface subsystem and resubmit the print
job. |
19 | 04 | An error occurred on the application
side. | Read the other messages to see what action is necessary. |
1C | 02 | Another message indicates the cause
of the problem. | Correct the error and resubmit the print job. |
Other
codes | A possible logic error exists. | Contact your service representative at the IBM Support Center, or use your electronic link
with IBM for assistance. |