CEMT SET FETARGET

Change the state of FEPI targets.

Syntax

Press the Clear key to clear the screen. You can start this transaction in two ways:
  • Type CEMT SET FETARGET (or suitable abbreviations for the keywords), followed by either a targetname or ALL . The resulting display lists the current status, similar to that obtained by using the CEMT INQUIRE FETARGET command. You can tab to the highlighted service state field and overtype it with a new value.
  • Type CEMT SET FETARGET (or suitable abbreviations for the keywords), followed by either a targetname or ALL , then followed by a service state setting. For example, cemt s fet fetarg1 i specifies that the target named fetarg1 is in service and available for use by a conversation.
Typing ? at the beginning of either the first or second line gives a syntax prompt. Resetting the values takes effect immediately.

CEMT Set FETarget

Read syntax diagramSkip visual syntax diagram CEMT Set FETarget (targetname)AllINSErviceOutservice

Options

All
Specifies that any change you request is made to all targets that you are authorized to access.
INSErvice
Specifies that the target is in service and can be used in a conversation.
Outservice
Specifies that the target is out of service and cannot be used for any new conversations, although existing conversations are unaffected. The service state is GOINGOUT until the existing conversations end.
( targetname )
Specifies the 8-character name of the target to be changed.