subscribe iconSubscribe to this information
POWER7 information

MAP 2410: 7031-D24 or 7031-T24 repair verification

Use this MAP to help you verify a repair after a FRU is exchanged for a new one on a 7031-D24 or 7031-T24 disk subsystem.

Attention: Do not remove power from the host system or the disk subsystem unless you are directed to in the following procedures. Power cables and external SCSI cables that connect the disk subsystem to the host system can be disconnected while that system is running.
  1. Ensure that the DC On/Off switch of each power supply assembly is set to On.
    Are all Check LEDs off?
    No
    Go to MAP 2010: 7031-D24 or 7031-T24 start.
    Yes
    Go to step 2.
  2. Can the host system access all SCSI devices?
    No
    Go to MAP 2010: 7031-D24 or 7031-T24 start.
    Yes
    The repair is complete.

    Go to MAP 0410: Repair checkout for system level repair verification.

Parent topic: 7031-D24 or 7031-T24 maintenance analysis procedures

Send feedback Rate this page

Last updated: Thu, September 25, 2014