lsiscsistorageportcandidate

Edit online

Use the lsiscsistorageportcandidate command to display a concise or detailed list of information about the candidate Internet Small Computer Systems Interface (iSCSI) target controller iSCSI Qualified Name (IQN) that is specified with the target IP from the specified initiator source ports.

Syntax


1  lsiscsistorageportcandidate
1  -node
2.1 node_id
2.1 node_name
2?  lsiscsistorageportcandidate-rowid

Parameters

-delim delimiter
(Optional) Specify a delimiter to separate data in the output.
-nohdr
(Optional) Suppress the headings in the output.
-node node_name | node_id
(Optional) Specifies the ID or name of a node in the system. The value must be an alphanumeric string.
lsiscsistorageportcandidate-rowid
(Optional) Specifies a row ID shown in the concise view to provide a detailed view of information about discovered portal IPs.

Description

This command lists information about the last invocation of the detectiscsistorageportcandidate command. This command can also display two types of lists:
  • A concise list of information about the candidate iSCSI target controller IQNs that are visible at the specified target IP from the specified initiator ports along with indication of which initiator ports can see each discovered iSCSI target IQN.
  • The detailed information about all the Target Controller Portal IPs discovered during the last invocation of the detectiscsistorageportcandidate command.
This table provides the attribute values that can be displayed as output view data.
Table 1. lsiscsistorageportcandidate output
Attribute Description
id Indicates the row ID for the discovery output. Enter the detectiscsistorageportcandidate command before you use the lsiscsistorageportcandidate command. Display the concise view first to show one row per IQN. Use a row ID from the concise view to specify the detailed view of the lsiscsistorageportcandidate lsiscsistorageportcandidate-rowid command. The detailed view displays the list of discovered target IP addresses for the IQN.
src_port_id Indicates the source port ID. The value is a number 1 - 8.
target_ipv4 Indicates the target IPv4 address.
target_ipv6 Indicates the target IPv6 address.
target_iscsiname Indicates the (discovered) IQN that uses the target controller. The value is an alphanumeric string that is 256 characters long.
iogroup_list Indicates a colon-separated list of discovery result codes: The value must be an alphanumeric string of up to 32 characters. This field cannot be blank. The values are 0 and 1:
  • 0 indicates that the I/O group is available in the system, but discovery is either not triggered through the I/O group or discovery through the I/O group fails.
  • 1 indicates that the I/O group is present and discovery is successful through the I/O group.
Note: The value - (dash) indicates that the I/O group is not valid or is not present in the system.
status Indicates whether discovery was successful. The status is one of the following values:
  • full
  • partial
  • none
configured Indicates whether the discovered target IQN has any established sessions with source ports or target ports. The values are yes and no (default).
site_id Indicates the site ID (if the nodes that are being discovered belong to a site). This attribute applies to HyperSwap® systems.
site_name Indicates the site name (if the nodes that are being discovered belong to a site). This attribute applies to HyperSwap systems.
SendTargets Portal IPs Provides list of all the (Maximum 32) discovered Target Portal IPs by using the detectiscsistorageportcandidate command.