IFC135I    PROCESSING TERMINATED, ddname {READ|WRITE} ERROR

Explanation

(MVS and VM) A permanent I/O error has occurred on the ddname data set.

MVS note: This message can be the result of a queuing situation or an inability to read the file.
VM note: If ddname is ACCDEV, the following may have occurred: the user does not want the records accumulated, but has failed to code ACC=N; so the default of ACC=Y is in effect. If tape 181 is not attached to the virtual machine, this I/O error results.

System action

EREP terminates; the records are not accumulated.

Programmer response

For VM: If the situation described in the note applies, rerun the job with ACC=N. Otherwise, move the volume containing the data set to another volume, to determine if the problem has been caused by a hardware malfunction.

For MVS: If the file was queued by another job, wait for the conflicting job to end and then rerun this job. Otherwise, move the volume or data set to determine if the problem has been caused by a hardware malfunction. If the message recurs, execute the SPZAP (VS2), or HMASPZAP (VS1) service aid program to obtain a dump of the data set on which the input error has occurred. If the error occurs on SYS1.LOGREC, run the IFCDIP00 program to reinitialize the data set.

Problem determination

Table 1, items 1, 2, 4, 5.

Attention: Move the suspect volume only once to ascertain a fault. Indiscriminate mounting and demounting of the disk pack can cause the destruction of packs and drives.
REQTEXT
Parent topic: EREP Messages