EREP control statements provide information about your configuration and set overall criteria for the way you want EREP to create a report. The following table lists the types of control statements and describes how each affects the EREP run.
| CONTROL STATEMENTS | WHAT THEY DO | SEE TOPIC |
|---|---|---|
| CONTROLLER | Tells EREP to combine the error records associated with this particular control unit and its attached devices. This control statement only applies to the system summary and threshold reports. | CONTROLLER Control Statement |
| DASDID | Tells EREP that this is the configuration of the 33XX DASDs within each subsystem; identifies those that do not provide physical IDs for the system exception report series. This control statement applies only to the system exception report series. | DASDID Control Statement |
| ENDPARM | Tells EREP that this is the end of the in-stream EREP parameters; the in-stream data that follows consists of EREP control statements. | |
| LIMIT | Tells EREP to produce output for the system exception reports only when the number of megabytes processed per error is less than the megabytes specified by the error frequency value and the number of times the error occurs is greater than or equal to the number specified by the count value. This control statement applies only to the system exception report series. | LIMIT Control Statement |
| SHARE | Tells EREP to combine the records for these devices that are shared between systems. This control statement applies to all the reports that generate I/O device summaries. | SHARE Control Statements |
| SYSIMG | Tells EREP to modify the CPU serial numbers for n-way processors so that those processors operating in the same system image are reported under the same CPU serial number. | SYSIMG Control Statement |