Explanation
A previous error required that the operator stop
sharing processors. The system recovered from the error.
The
right-most four bytes of the program status word (PSW) have the following
format:
xrrr0www
where:
- x
- Irrelevant information.
- rrr
- A hexadecimal reason code indicating the reason for the failure.
- www
- The wait state code.
The reason code (
rrr) is one of the
following:
- 001
- Reserves are intact. The system successfully recovered the reserved
devices.
- 002
- Reserves are lost. The system forced one or more devices that
are reserved for the system offline.
System action
The system enters wait state X'114' because
it could not issue message IOS201E. The system waits for the operator
to restart the system.
Operator response
Do the following:
- Isolate the failing channel path for repair.
- Identify and recover failing tasks.
- If the reason code indicates that reserves are intact, do the
following:
- Enter the IOACTION RESUME command for the device on all other
sharing systems if the device was stopped, or restart any stopped
systems, or vary the device back online. Start the stopped processors
by pressing the START key at the system console of each sharing system
or logical partition.
- Perform a system restart on the system that detected the stopped
processor.
- If the reason code indicates that reserves are lost, do the following:
- Enter the IOACTION RESUME command for the device on all other
sharing systems if the device was stopped, or restart any stopped
systems, or vary the device back online. Start the stopped processor
by pressing the START key at the system console of each sharing system
or logical partition.
- Perform a system restart on the system that detected the stopped
processor.
- Notify the system programmer.
Source
Input/output supervisor (IOS)