EZD1974E

Explanation
 Sysplex problem detection determined that storage
managed by the communications storage manager (CSM) has been constrained
for multiple monitoring intervals.  
 In the message text:  tcpstackname
The name of the TCP/IP stack.
timevalue
The number of seconds that syplex problem detection has determined
 that CSM has been constrained.

System action
 TCP/IP continues.
 If the GLOBALCONFIG
SYSPLEXMONITOR RECOVERY option is active, and this stack is  not the
only member of the TCP/IP sysplex group, the following RECOVERY actions
 will occur:  This stack will leave the sysplex group.
This stack will no longer participate in sysplex distribution
(as a distributor or target) or act as an owner or a backup for DVIPAs.
 All DVIPAs defined on  this stack will be deactivated; however, the
DVIPA definitions will be saved.
If the problem is corrected, this operator message will be deleted.
If the  GLOBALCONFIG SYSPLEXMONITOR AUTOREJOIN option is active, the
stack will process the DVIPA definitions and rejoin the TCP/IP sysplex
group.

If the GLOBALCONFIG SYSPLEXMONITOR NORECOVERY option is active,
no action will  be taken. Monitoring will continue. This operator
message will be deleted  when the CSM constraint is corrected.
 See sysplex problem detection and recovery in z/OS Communications Server: IP Configuration
Guide for more information.

Operator response
 Save the TCP/IP profile and system log. If
a dump was not created, take a dump  of the TCP/IP address space and
dataspaces, and the CSM dataspace.

System programmer response
 Messages were issued before this
message to report that CSM storage is constrained. Those messages
identify the type of CSM storage that is constrained. See the documentation
for those messages for the actions that you must take to resolve the
storage constraint.
 If the CSM storage problem cannot be corrected,
contact your IBM® support center
with the documentation that was obtained when the problem occurred.
 If
the CSM storage problem can be corrected: If RECOVERY is being used, enable the stack to rejoin the sysplex
group. Message EZZ9676E is issued after the process of leaving the
sysplex group has  successfully completed.  After this message is
issued, reapply the sysplex  profile definitions by issuing VARY OBEY.
This will cause the stack to rejoin the sysplex group.
If NORECOVERY is being used, no further actions are needed.

User response
 Not applicable.

Problem determination
 Not applicable.

Source
 z/OS® Communications
Server TCP/IP: Configuration & Initialization

Module
 EZBXFPDM

Routing code
 2, 8

Descriptor code
 2

Automation
 Not applicable.

Example
  EZD1974E TCPCS1 CSM HAS BEEN CONSTRAINED FOR AT LEAST 90 SECONDS