Problems with output of HCD textual reports
Use this procedure if you find problems that relate to the HCD report facility.
- Check the output of the report job for messages that provide additional
information.
- For incorrect or incomplete output:
- Compare the contents of the IODF with the output. For example, if the
device features are not shown correctly in the OS device detail report, use
the action View device definition on the I/O
Device List to display the definitions of the device for which the report
seems to be incorrect.
- If you find out that the definitions in the IODF are correct, but the
report output is incorrect, report this problem to IBM.
Table 23 shows what the problem data could look like.
Table 23. Problem DataProblem Data | Example |
---|
Type of report that was to be created. | Control unit detail report | JCL that was used to create the report. | | The content of the IODF for which the report
was requested.
Refer to TRACE command to create an IODF dump. | |
|