Enabling and disabling a Virtual Trusted Platform Module on a logical partition
You can enable a Virtual Trusted Platform Module (VTPM) on a logical partition by using the Hardware Management Console (HMC), after the logical partition is created.
To enable a VTPM, ensure that an AIX®, Linux or a Virtual I/O Server (VIOS) logical partition is in the Not activated
state.
The HMC Classic interface is not supported in Hardware Management Console (HMC) Version 8.7.0, or later. The functions that were previously available in the HMC Classic interface are now available in the HMC Enhanced+ interface.
For information about enabling VTPM on a logical partition when the HMC is at version 8.7.0, or later, see Changing advanced partition settings.
To enable a VTPM on a logical partition, complete the following steps:
If you dynamically enable a VTPM on a logical partition, the
VTPM function is activated only at the next logical partition activation.
However, disabling a VTPM takes effect immediately.
To dynamically disable a VTPM, log on to the AIX, Linux or VIOS logical partition
and disable the Trusted Computing Services daemon (tcsd) by using
the stopsrc command. When the tcsd software
is stopped, the device must be removed from the AIX logical
partition by using the rmdev command. After the
device is successfully deleted from the AIX logical
partition, use the HMC to
clear the VTPM check box from the properties of the partition. This
completely removes the device and deletes all stored data that is
associated with the VTPM.