QRadar: Recon script returns error 'endpoint not specified'

Troubleshooting

Problem

After you run the command /opt/qradar/support/recon ps to check the status of the apps, it returns error "endpoint not specified".

NOTE: This utility should only be run from where the apps are running (Console or AppHost if it exists)

Symptom

/opt/qradar/support/recon ps
&ps.StatusResult{Check:(*ps.StatusCheck)(nil), Message:"endpoint not specified", Remediation:"", Value:1}

Document Location

Worldwide

[{"Type":"MASTER","Line of Business":{"code":"LOB77","label":"Automation Platform"},"Business Unit":{"code":"BU048","label":"IBM Software"},"Product":{"code":"SSBQAC","label":"IBM Security QRadar SIEM"},"ARM Category":[{"code":"a8m0z000000cwt3AAA","label":"QRadar Apps"}],"ARM Case Number":"","Platform":[{"code":"PF016","label":"Linux"}],"Version":"7.4.1;7.4.2;7.4.3"}]

Log InLog in to view more of this document

This document has the abstract of a technical article that is available to authorized users once you have logged on. Please use Log in button above to access the full document. After log in, if you do not have the right authorization for this document, there will be instructions on what to do next.

Was this topic helpful?

Document Information

More support for:
IBM Security QRadar SIEM

Component:
QRadar Apps

Software version:
7.4.1, 7.4.2, 7.4.3

Operating system(s):
Linux

Document number:
6489911

Modified date:
24 February 2023

UID

ibm16489911

IBM Support

Tips