Power part numbers - Netfinity 5100

Content

NOTE: The Netfinity 5100 includes a single 250W, hot-swap power supply and a single 9 ft. 110V power cord with an IEC 320-C13 connector on the system end and NEMA 5-15P on the other end. Power supply redundancy may be achieved with the addition of the optional Netfinity 250W Hot-Swap Redundant Power Supply (part number 33L3760). The Netfinity Hot-Swap Power Supply Upgrade Kit (part number 37L6881) is required when optional power supplies are to be added. Redundancy for configurations of greater than 250W requires installation of a second optional supply. Whenever devices are installed in bays A or B, both the expansion kit and a second power supply are required. Generally, configurations containing greater than six PCI adapters and hard disk drives, in any combination, will require the second power supply. To assist in determining when an additional power supply is required to preserve redundancy, a Non-Redundant LED is a standard feature of the Netfinity 5100 .

Standard parts listing

(1) 250W Hot-Swap Redundant Power Supply (part number 33L3760) includes a single 6 ft.power cord for connection to a low voltage wall outlet. Hot-Swap Power Supply Expansion Kit (part number 37L6881) must be installed prior to adding optional power supplies.
(2) Includes a hot-swap power backplane, terminated two-drop LVD SCSI cable, and mounting brackets for DLT tape drives. Required when installing a second power supply or devices in the 133-mm (5.25") HH bays.
(3) Replaced by part number 37L6866