IBM Support

No beep symptoms - IBM eServer xSeries 340

Troubleshooting


Problem

No beep symptoms for the IBM eServer xSeries 340.

Resolving The Problem

 

No beep symptom FRU/Action
No beep and the system operates correctly
  1. Check speaker cables
  2. Speaker
  3. System board
No beeps occur after successfully completing POST
(Power-On Status is disabled)
  1. Run Configuration/Setup; set the Start Options Power-On Status to enable
  2. Check speaker connection
  3. System board
No AC power
(Power supply AC LED is off)
  1. Check the power cord
  2. Power supply (If two are installed, swap them to determine if one is defective)
  3. Power backplane
  4. Hot-swap power AC inlet box
No beep and no video
  1. See "Undetermined problems" in the Hardware Maintenance Manual (HMM)
System will not power-up
(Power supply AC LED is on)
  1. See "Power supply LED errors" in the HMM

Document Location

Worldwide

Operating System

Older System x:Operating system independent / None

[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW18M","label":"Older System x->xSeries 340"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]

Document Information

Modified date:
28 January 2019

UID

ibm1MIGR-41056

Page Feedback