Remote Supervisor Adapter Firmware Update Utility - IBM eServer xSeries 450 (Type 8688) and 455 (Type 8855)

Download Description

New IBM xSeries firmware and device driver file naming convention

Version 1.09, MZET46A

Problem(s) Fixed:

Enhancement:

• Added support for the year 2007 US Daylight Saving Time changes
• Added Daylight Saving Time support for western Australia

Limitations:
Dependencies:

Version 1.08, MZET45A

• Corrected a problem that caused a seconadry node to power off when the operating system initiated a system reset
  

Version 1.07, MZET44A

• Updated the ISMP firmware to include support for additional CPU ID's
• The ISMP firmware was corrected to eliminate false readings that can occur immediately after the ISMP is rebooted
• Corrected a problem with the wrong DIMM being reported when an uncorrectable memory error occurred

Version 1.06, MZET42A

• Fixed problem with reassigning primary node when changing scalable partition configuration
• Corrected problem in multinode configuration where primary node restarted while secondary nodes boot up
• Fixed infrequent problem with board LED turning on upon system shutdown
• EFI command "reset -s" no longer causes secondary nodes to restart prior to shutdown

Version 1.05, MZET41A

• Modified RXE-100 configuration support in a multinode environment.

Version 1.04, MZET40A

• Added support for larger file sizes for BIOS and Diagnostics remote updates.
• Fixed problem of multiple entries for UPD Checksum errors in event log.
• Added support for SSL and Lightweight Directory Access Protocol
• Fixed problem where VRM failures did not generate alerts or error log entries.
• Corrected intermittent machine check that occurred during power cycling.
• Fixed problem where a RXE-100 UUID was not reported correctly in a multinode environment.

Version 1.03, MZET34A

• Vital Product Data for CPU card and Memory card swapped.
• Modified flash update utility to update a multi-node configuration from the primary node.
• Fixed intermittent 1615 errors.
• Flash utility shows RXE-100 level as 0 when connected to side B.

Version 1.02, MZET24A

• Voltage values for RXE-100 would read zero if no RXE-100 was installed.
• Fixes for intermittent instruction faults.

Version 1.01, MZET23A

• Corrected false power fault messages on some models (including RXE-100).
• Resolved situation which would warrant the following log entry "1614 - SP Error 1: attempting L4 initialization."
• Enhanced remote graphics over TCP/IP connection.

Version 1.00, MZET19A

• First release