Troubleshooting
Problem
Instructions for installing the cover
Resolving The Problem
The following information describes the cover installation procedure.
- Clear any cables that might impede the replacement of the clear shield or the cover.
- Install the clear shield, if it was removed.
Note: Thermal considerations require that the clear shield be installed before operating the server.
- Install the cover by placing it into position and sliding it forward. Make sure the cover engages the tabs at the front and rear of the server.
WARNING: Before sliding the cover forward make sure that all of the tabs on the cover will engage the ledge at the front of the server properly. If all of the tabs do not engage the ledge properly, it will be extremely difficult to remove the cover.
- Install the screws and secure the cover as shown.
- Reinstall the server in the rack.
- Reconnect the power cord and all external cables to the server, then plug the power cords into electrical outlets.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW18E","label":"Older System x->xSeries 135"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU016","label":"Multiple Vendor Support"},"Product":{"code":"HW18L","label":"Older System x->xSeries 330"},"Platform":[{"code":"PF025","label":"Platform Independent"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
23 January 2019
UID
ibm1MIGR-45143