Product Documentation
Abstract
8231-E2B (Power 710, Power 730) - Low profile PCI card removal movie
Content
Low profile PCI card removal
To remove the Low profile PCI card, follow these steps:
- Remove the service access cover.
- Disconnect the power source from the system by unplugging the system.
- Determine which adapter you plan to remove, and then label and disconnect all cables attached to that adapter.
- Record the slot number and location of each adapter being removed.
NOTE: Adapter slots are numbered on the rear of the system. - If the adapter latch is not already in the open position, pull the latch into the open position by pressing down on it from its hold on the back of the system.
- Carefully grasp the PCI adapter by its top edge or tailstock, and remove it from the system. Store the adapter in a safe place.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1N1","label":"Power->Power 710"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1R1","label":"Power->Power 730"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5087237