Product Documentation
Abstract
8202-E4B (Power 720) and 8205-E6B (Power 740) - RAID Package removal movie
Content
RAID package removal
To remove the RAID package, follow these steps:
- Ensure the system is powered down. Check the operator panel to see that the power LED is flashing on or off.
- Remove the front cover.
- Remove the service access cover.
- Check the status of the green Write Cache LEDs on cards located in P1-C19 and P1-C14.
- Disconnect the power source from the system by unplugging the system.
- Locate the RAID enablement card that you want to remove.
- Press the tab and slide the card out of the system as shown in the following figures. The RAID enablement card is attached to a metal plate. You must slide the metal plate out of the system to remove the RAID enablement card.
For specific instructions for the removal and installation of hardware.
Document Location
Worldwide
[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1P1","label":"Power->Power 720"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1S1","label":"Power->Power 740"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]
Was this topic helpful?
Document Information
Modified date:
24 January 2019
UID
ibm1MIGR-5087178