IBM Support

Memory VRM (20 amp) removal - 8202-E4B (Power 720), 8205-E6B (Power 740)

Product Documentation


Abstract

8202-E4B (Power 720) and 8205-E6B (Power 740) - memory vrm (20 amp) removal movie

Content

Memory VRM (20 Amp) removal

To remove the Memory VRM (20 Amp), follow these steps:

  1. Remove the service access cover.
  2. Disconnect the power source from the system by unplugging the system.
  3. Remove the memory riser from the system:
    1. Pull the locking tabs into the open position.
    2. Lift the memory riser out of the system.
  4. Locate the memory voltage regulator module to be removed from the system processor assembly.
  5. Press the blue button to identify the failed voltage regulator module.
  6. Remove the memory voltage regulator module from the connectors.
    1. Grasp the top edges of the memory voltage regulator module to loosen them from the connectors.
    2. Place your thumb under the bottom edge of the voltage regulator module and lift it to remove the module from the connectors.
  7. Place the voltage regulator module on an electrostatic discharge (ESD) surface.

For specific instructions for the removal and installation of hardware.

Document Location

Worldwide

[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1P1","label":"Power->Power 720"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1S1","label":"Power->Power 740"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]

Document Information

Modified date:
24 January 2019

UID

ibm1MIGR-5087136

Page Feedback