SAS riser-card and controller assembly installation movie - IBM System x3650 M2 (7947), x3650 M3 (7376, 7945)

Content

• Movie player help

Text from the audio portion of the SAS riser-card and controller assembly installation movie

To install the SAS Riser-card and Controller Assembly:

1. Connect the cable from the daughter card to the battery and place the battery and daughter card on the controller using the screw holes for alignment and secure with the three screws.
2. Seat the riser card on the controller.
3. Place the front end of the SAS controller in the retention bracket then lower the SAS controller onto its connector using the locating pins on the 240 Volt Amp safety cover for alignment.
4. Press down on the SAS controller until the card is firmly seated and the retention latch clicks into place.
5. Connect the two SAS Data Cables.
   Here is a closer look at the retention bracket.
   Here is a closer look at the alignment pins.
6. Install the Top Cover:
   1. With the cover release latch in the open position place the cover over the chassis so that the tabs in the cover align with the slots in the chassis.
   2. Slide the cover forward while rotating the cover release latch down to the closed position.
      Here is a closer look at a tab on the cover and a slot in the side of the chassis.

• View the SAS riser-card and controller assembly removal movie
• Return to matrix

For specific instructions for the removal and installation of hardware.

• Problem Determination and Service Guide - IBM System x3650 M2