IBM Support

SAS RAID enablement card installation - 8233-E8B (Power 750), 8236-E8C (Power 755)

Product Documentation


Abstract

8236-E8C (Power 755) and 8233-E8B (Power 750) - SAS RAID enablement card "installation" movie

Content

SAS RAID enablement card installation

To install the SAS RAID enablement card, follow these steps:

  1. Align the RAID enablement card with the slot in the system.
  2. Slide the RAID enablement card fully into the system until the tab locks into place.
  3. Replace the service access cover.
    1. Place the service access cover on the top of the system unit, approximately 25 mm (1 in.) from the front of the system unit.
    2. Hold the service access cover against the system unit, and slide it toward the front of the system.
    3. Tighten the screws located at the back of the cover.
  4. Place the system in the operating position.
    1. To unlock the rail safety latches, slide the latches toward the front of the system.
    2. Push the system unit back into the rack until both system-unit release latches lock into position.
    3. Replace and tighten the two screws that secure the system unit to the rack.

For specific instructions for the removal and installation of hardware.

Document Location

Worldwide

[{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1H1","label":"Power->Power 750"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}},{"Type":"HW","Business Unit":{"code":"BU054","label":"Systems w\/TPS"},"Product":{"code":"HW1K1","label":"Power->Power 755"},"Platform":[{"label":"Platform Independent","code":"PF025"}],"Line of Business":{"code":"","label":""}}]

Document Information

Modified date:
24 January 2019

UID

ibm1MIGR-5084986

Page Feedback