PCI adapter installation - 8233-E8B (Power 750), 8236-E8C (Power 755)

Content

• Movie player help

PCI adapter installation

To install the PCI adapter, follow these steps:

1. Carefully grasp the adapter by its top edge, and align the adapter with the expansion slot and its connector on the system backplane.
2. Press the adapter firmly into its connector.
3. Slide the adapter latch back into place.
4. Replace the service access cover.
   1. Place the service access cover on the top of the system unit, approximately 25 mm (1 in.) from the front of the system unit.
   2. Hold the service access cover against the system unit, and slide it toward the front of the system.
   3. Tighten the screws located at the back of the cover.
5. Place the system in the operating position.
   1. To unlock the rail safety latches, slide the latches toward the front of the system.
   2. Push the system unit back into the rack until both system-unit release latches lock into position.
   3. Replace and tighten the two screws that secure the system unit to the rack.

• View PCI adapter removal movie
• Return to components list

• Power Hardware Information Center