USB Cable installation movie - IBM System x3550 (Type 1013, 1913, 7978)

Content

• Movie player help

To install the USB Cable:

1. While squeezing the spring latches position the connector into the cutout in the chassis. Release the spring to secure the latches in place.
2. Due to the limited access in the media bay a flat probe may be useful..
3. Insert the hinge tabs on the bottom of the bezel into the slots in the chassis.
4. Rotate the top of the bezel towards the system until flush with the chassis and secure with the two screws.
5. Route the video cable and the USB cable through the slot in the chassis and connect them to the system board.
6. Position fan number 4 over the bracket insuring that the air flow indicator is pointing to the rear of the server.
7. Push the fan assembly down until the blue mounting grommets are seated.
8. Push the Disk Drive Bay Cage Assembly into the bay until flush with the chassis and secure with the three screws.

Install the Top Cover:

1. Position the cover over the chassis aligning the tabs in the cover with the slots in the chassis.
2. Slide the cover forward and secure with the single captive screw.
3. Rotate the Fan Door to the closed and latched position.

• Problem Determination and Service Guide