Front USB assembly installation movie - IBM System x3850 M2 (7141, 7144), x3950 M2 (7141)

Content

• Movie player help

To install the Front USB assembly:

1. To install the cable, squeeze the spring clips on the sides of the cable while inserting it into the bracket. Release the spring clips to secure the cable.
2. Thread the USB cable through the opening.
3. Insert the tab at the opening, and rotate the bracket until it snaps in place.
4. Connect the USB cable to the USB connector on the I/O board.
5. Route the cable through the cable channel. To minimize cabling problems, the DVD cable should be on top with the USB cable underneath it.
6. Close the spring clip to secure the cables in the channel.

Install the Top cover:

1. Position the cover on top of the server so that the tabs on the cover align with the slots on the chassis.
2. Make sure that the cover-release latch is up.
3. Slide the top cover forward while pressing the release latch closed.

Install the Bezel:

1. Position the bezel alignment pins in the matching chassis holes; then, press the bezel in until secured by the latches.

Install the Top cover:

1. Position the cover on top of the server so that the tabs on the cover align with the slots on the chassis.
2. Make sure that the cover-release latch is up.
3. Slide the top cover forward while pressing the release latch.

• Problem Determination and Service Guide