Operator information panel assembly removal movie - IBM System x3755

Turn off the server and peripheral devices, and disconnect all power cords and external cables.

Remove the top cover:

1. Rotate the top cover release latch up and slide the cover approximately one-half inch to the rear.
2. Lift the cover off and place it aside.

1. Open the fan-locking handle on fan number one by sliding the release latch in the direction of the arrow.
2. Pull up on the handle to lift the fan out of the server.
3. Disconnect the Operator Information Panel ribbon cable from the I/O board.
4. Separate the hook-and-loop fastener that holds the ribbon cable to the chassis.
5. Slide the operator information panel release latch to the left and pull the panel out of the server as far as it will go.
6. Press the release tabs through the holes in the bezel and then carefully pull the assembly and the ribbon cable out of the server.
   Note: A small jeweler's screwdriver or similar tool is required to access the holes in the bezel.

• View the operator information panel assembly installation movie
• Return to matrix